Thread: Broadcom BCM4401 100Base-T wired

hello all. have been looking @ posts card.

system --
dell 5150 laptop.
wireless thru usb works fine
wired inop.

here returns form ifconfig:
nj0e@nj0e-laptop:~$ ifconfig
eth0 link encap:ethernet hwaddr 00:0b:db:99:0f:4f
inet6 addr: fe80::20b:dbff:fe99:f4f/64 scope:link
broadcast running multicast mtu:1500 metric:1
rx packets:0 errors:0 dropped:0 overruns:0 frame:0
tx packets:3 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
rx bytes:0 (0.0 b) tx bytes:250 (250.0 b)
interrupt:7

lo link encap:local loopback
inet addr:127.0.0.1 mask:255.0.0.0
inet6 addr: ::1/128 scope:host
loopback running mtu:16436 metric:1
rx packets:19244 errors:0 dropped:0 overruns:0 frame:0
tx packets:19244 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
rx bytes:9433057 (9.4 mb) tx bytes:9433057 (9.4 mb)

wlan0 link encap:ethernet hwaddr 00:0f:3d:4b:ae:c6
inet addr:192.168.0.147 bcast:192.168.0.255 mask:255.255.255.0
inet6 addr: fe80::20f:3dff:fe4b:aec6/64 scope:link
broadcast running multicast mtu:1500 metric:1
rx packets:265380 errors:0 dropped:0 overruns:0 frame:0
tx packets:85446 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
rx bytes:132345814 (132.3 mb) tx bytes:15595840 (15.5 mb)

, return lshw -c network:

nj0e@nj0e-laptop:~$ lshw -c network
warning: should run program super-user.
*-network
description: ethernet interface
product: bcm4401 100base-t
vendor: broadcom corporation
physical id: 1
bus info: pci@0000:02:01.0
logical name: eth0
version: 01
serial: 00:0b:db:99:0f:4f
width: 32 bits
clock: 33mhz
capabilities: bus_master cap_list ethernet physical
configuration: broadcast=yes driver=b44 driverversion=2.0 latency=32 module=ssb multicast=yes
*-network
description: wireless interface
physical id: 3
logical name: wlan0
serial: 00:0f:3d:4b:ae:c6
capabilities: ethernet physical wireless
configuration: broadcast=yes driver=ndiswrapper+prisma02 driverversion=1.53+globespanvirata,11/11/2003, ip=192.168.0.147 multicast=yes wireless=ieee 802.11g

, lspci:
nj0e@nj0e-laptop:~$ sudo lspci
00:00.0 host bridge: intel corporation 82845g/gl[brookdale-g]/ge/pe dram controller/host-hub interface (rev 03)
00:01.0 pci bridge: intel corporation 82845g/gl[brookdale-g]/ge/pe host-to-agp bridge (rev 03)
00:1d.0 usb controller: intel corporation 82801db/dbl/dbm (ich4/ich4-l/ich4-m) usb uhci controller #1 (rev 02)
00:1d.1 usb controller: intel corporation 82801db/dbl/dbm (ich4/ich4-l/ich4-m) usb uhci controller #2 (rev 02)
00:1d.2 usb controller: intel corporation 82801db/dbl/dbm (ich4/ich4-l/ich4-m) usb uhci controller #3 (rev 02)
00:1d.7 usb controller: intel corporation 82801db/dbm (ich4/ich4-m) usb2 ehci controller (rev 02)
00:1e.0 pci bridge: intel corporation 82801 pci bridge (rev 82)
00:1f.0 isa bridge: intel corporation 82801db/dbl (ich4/ich4-l) lpc interface bridge (rev 02)
00:1f.1 ide interface: intel corporation 82801db (ich4) ide controller (rev 02)
00:1f.5 multimedia audio controller: intel corporation 82801db/dbl/dbm (ich4/ich4-l/ich4-m) ac'97 audio controller (rev 02)
00:1f.6 modem: intel corporation 82801db/dbl/dbm (ich4/ich4-l/ich4-m) ac'97 modem controller (rev 02)
01:00.0 vga compatible controller: ati technologies inc radeon mobility m7 lw [radeon mobility 7500]
02:01.0 ethernet controller: broadcom corporation bcm4401 100base-t (rev 01)
02:04.0 cardbus bridge: texas instruments pci4510 pc card cardbus controller (rev 02)
02:04.1 firewire (ieee 1394): texas instruments pci4510 ieee-1394 controller


stated have wirless connection fine. when try use wired connection won't connect.

using wicd conneciton tool instead of network manager had problems network manager vs wirless card.

apprieciate help

joe

bump???

Forum The Ubuntu Forum Community Ubuntu Official Flavours Support Networking & Wireless [ubuntu] Broadcom BCM4401 100Base-T wired

Ubuntu