I am having trouble using the Arduino as an AVR ISP "Device signature = 0x00000"
i want use arduino isp programmer (just programming barebones atmega using c) , have following problem. use arduinoisp code comes in default arduino ide, upload code, , then:
avrdude -p m328p -p /dev/ttyacm0 -c avrisp -b 19200 -b 6
avrdude: avr device initialized , ready accept instructions
reading | ################################################## | 100% 0.06s
avrdude: device signature = 0x000000
avrdude: yikes! invalid device signature.
double check connections , try again, or use -f override
this check.
avrdude done. thank you.
as far connections go, don't think made mistake. compare datasheet of 328p-pu , i've done on breadboard , double-check wiring arduino , fail see problem. assume using -f unsafe. should do? here picture. it's taken laptop apologize poor quality. http://i.imgur.com/4k4lrbk.jpg
i beginner in bash, programming , electronics apologize if make dumb mistake.
avrdude -p m328p -p /dev/ttyacm0 -c avrisp -b 19200 -b 6
avrdude: avr device initialized , ready accept instructions
reading | ################################################## | 100% 0.06s
avrdude: device signature = 0x000000
avrdude: yikes! invalid device signature.
double check connections , try again, or use -f override
this check.
avrdude done. thank you.
as far connections go, don't think made mistake. compare datasheet of 328p-pu , i've done on breadboard , double-check wiring arduino , fail see problem. assume using -f unsafe. should do? here picture. it's taken laptop apologize poor quality. http://i.imgur.com/4k4lrbk.jpg
i beginner in bash, programming , electronics apologize if make dumb mistake.
if configured external clock:
Arduino Forum > Using Arduino > Microcontrollers > I am having trouble using the Arduino as an AVR ISP "Device signature = 0x00000"
arduino
Comments
Post a Comment