MOSFET Driver General Control/Activation

hey guys,

i'm trying control inductive load  via mosfet ic driver connected arduino unit, such this:

http://www.digikey.com/product-detail/en/vnd5160jtr-e/497-11694-1-nd/2746923

i've never had previous experience ics had mosfets in them (mosfets -- that's matter); activation of a  driver such above generally  of relay, i.e. "on" or "off" dependent on 0/5v("hi"/"lo") output signal driver's input. i've read , re-read datasheet , thought it's explanation of on/off state rather cryptic.

closest lead find info on open load detection table on pg.11 has "on-state detection threshold" current value test condition of 5v vin, 8-18 vcc; mean, on state activation current-based vs. voltage based model?

thanks!

the max driver's input voltage (arduino driver) based on datasheet 3v cmos (driver's input1,2). may use resistive voltage divider go 5v 3v (ie 1k8/2k7).
the status1,2 read arduino inputs, need pullup @ arduino inputs (ie 10k wired arduino's +5v). everyhing else matter of table n.12 study..

Arduino Forum > Using Arduino > General Electronics > MOSFET Driver General Control/Activation

arduino