9v battery not supplying enough power?


so finished project on breadboard , began moving on to  small piece of strip board.  after soldering fired nothing happened...  started investigate multimeter , noticed voltage after 5v regulator power hovered @ around 5v... far good, after servo dropped 2.8ish v.  wasn't issue when set on bread board, there i'm missing?

servo's need amp or so.  perhaps before had usb power out?

4 aa rechargable cells power source of choice 6v servos, small 9v
alkaline batteries radios , other low current devices, can't provide
anything enough servos / motors - can power arduino alone.


Arduino Forum > Using Arduino > General Electronics > 9v battery not supplying enough power?


arduino

Comments

Popular posts from this blog

VIDIOC_S_FMT error 16, Device or resource busy - Raspberry Pi Forums

using a laptop skeleton to build a pi laptop - Raspberry Pi Forums

Forum for Joomla? - Joomla! Forum - community, help and support